C-1 CORE MIX is used to make preformed cores for use with ferrous castings. C-1 core mix is
exothermic as it sets which, in most cases, prevents it from being used in direct contact with wax patterns. If the core is small, such as with golf club hozzles, you can form the core against the wax
pattern without damage to the wax.
50/50 CORE MIX is used to hand pack cores and is typically used by ferrous casters. 50/50 core mix
is exothermic as it sets which, in most cases, prevents it from being used in direct contact with wax patterns. If the core is small, such as with golf club hozzles, you can form the core against the wax
pattern without damage to the wax.
CORE HARDENER 2000 is a water-based colloidal silica binder used to strengthen the ceramic
shell in small holes, slots and hart-to-reach openings. It helps prevent metal penetration by strengthening the shell which is usually thin in these areas. CORE HARDENER 2000 can also be
used to strengthen C-1 core mix, 50/50 core mix and 910 investment core material.
KWIK-CORETM MATERIAL
is a powder and binder system that is designed for hand packing cores to be used with ceramic shell. KWIK-CORE material is for use primarily with ferrous castings. KWIK-CORE
material can be poured directly into the cavity of the wax due to its low exothermic reaction.
910 INVESTMENT is a calcium sulfate bonded investment for cores. It is used with non-ferrous alloys
which do not exceed temperatures of 2200F (1200C). 910 investment has good green strength, good thermal shock resistance, is easily removed after casting and can be used directly in contact with
the wax pattern.
Some files on this site are available for downloading. You must have Adobe Acrobat Reader to view these files. If you do not have Adobe Acrobat Reader, you may download it by
clicking on the Adobe Acrobat Reader logo to the right. There is no charge for this software.