Flow Lines

Technical Support

Struggling with a specific casting defect or just need general technical support?

  • Irregular shallow round or angular grooves that appear on the surface of the casting

  • Indicates that the ceramic shell was built around a defective wax pattern

Causes of this defect are evident in the wax portion of the process; to cure, R&R recommends taking the following actions:

Wax

Excessive die lubricant, low injection pressure, cold wax, cold die, or poor flow rate.


Adjust the wax parameters to eliminate flow lines, temperature, pressure and flow rate.





R&R is a Proud Member of
ICI Digital Logo.jpg
EICF-logo.gif
MJSA-logo.jpg

Corporate Office

3535 Briarfield Boulevard
PO Box 1570 
Maumee, Ohio 43537 USA
US Toll Free: 800.253.4502
US Phone: 419.865.9497
US Fax: 419.865.9997

Email:

RR-Marketing@dentsply.com

RRCustomerService@dentsply.com

RR-Technical@dentsply.com

Contact Us

R&R Terms & Conditions

© 2019 by Ransom & Randolph